Skip to content
  • There are no suggestions because the search field is empty.

Adding a GCC Jaguar cutter to VerteLith

As you may know, GCC cutters are not officially supported in VerteLith. 

However, you can try the following workaround:


  • Add ValueCut as a cutter in VerteLith.
  • Manually enter the IP address as 127.0.0.1.
  • You may receive an error message—ignore it and continue by clicking Next through the setup steps.
  • Go to Manage Cutters.
  • Edit the IP address of the cutter to match the actual IP address of your GCC cutter.
  • Again, ignore any error messages and continue by clicking Next as needed.

Please note: This method is not guaranteed to work.